POWERED EARWAX REMOVER
INSTRUCTIONS
By
©2022 Allstar Innovations
Wush is a trademark of Allstar Innovations
Distributed by Allstar Innovations
Black Wolf is a registered trademark of
Black Wolf Opco, Inc.
Made in China | Patent Pending
Product Color and Appearance May Vary
1. Inserting and Replacing Irrigation Tip
Insert irrigation tip onto arm. Hold irrigation tip and
rotate the connector clockwise to secure. (Diagram A)
2. Charging the Unit
Charge unit using USB-C port and included charging
cable as shown in image. During charging each LED
will illuminate indicating percentage of charge at
each solid LED. When all LED’s are solid the unit is
fully charged. Low Battery Indicator all 3 LED’s will
flash at the same time indicating the battery is low
and the product needs to be charged. (Diagram B)
3. Pressure Settings
There are 3 mode pressure settings.
Low - Pressure level 1, Medium - Pressure level 2,
and High - Pressure level 3. (Diagram C)
4. Removing the Water Reservoir
Pull reservoir down from main unit. (Diagram D)
5. Cleaning the Water Reservoir
• Remove reservoir and wash the inside and outside
of tank with dishwashing solution and warm water.
• Dry exterior of tank with a dry cloth and allow
inside to air dry.
Connector
Power Button
USB-C Port
Water
Reservoir
Main Unit
Mode Button
High
Medium
Low
Irrigation Tip
A
C
B
D
This device complies with part 18 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This product has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 18 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
To Next Page
Need help?
General