G7 GETTING STARTED GUIDE
©2023 BLACKLINE SAFETY CORP
Rev. 11
G7 GETTING STARTED GUIDE | 1
2023-05-09
POWERING ON
What does the green light mean?
Flashing
Solid
A ashing connectivity light indicates that your
G7 is storing data. It is not currently connected to
the network and will send
data when the light is solid.
A solid connectivity light indicates that G7 is
actively transmitting data and is connected to
the Blackline Safety Network.
Press and hold the power
button for two seconds.
CHARGING
Micro USB cable
Removable charging clip
Charging port
1. Insert the micro USB cable into the removable
charging clip
2. Slide the charging clip onto the charging port
at the bottom of your G7
3. A solid red light at the bottom of the device
conrms your G7 is charging
MENU
To use G7’s menu:
1. Press OK once to wake up G7’s screen
2. Press OK again to enter the main menu
3. Use the up and down arrow keys to
navigate to the selection you would like
4. Press OK to select a menu item
5. Repeat as necessary
OK button Up and down buttons
SOS ALERT
If you are in need of assistance, you can pull down
the red latch to signal for help.
This feature must be enabled by your safety
supervisor. They can contact Blackline Customer Care
for setup assistance.
What is an SOS alert?
Power button
Charging light
Cartridge (standard,
single-gas or multi-gas)
Microphone
(G7c only)
OK button
Up button
LCD screen
Speaker
Latch pull
Latch push button
Down button
Operational and low urgency
Connectivity light
High urgency notication
LiveResponse
Top lights
OK
HARDWARE DETAILS
To Next Page
General
