You can find your HyperDeck Studio Mini’s
IPaddress in the smart panel’s ‘network’ screen
3 Enter your HyperDeck Studio Mini’s IP address into your TCP application’s connection
dialog. The naming and position of this box can vary between applications, but it is
usually labeled ‘server’ or ‘host.’ If your FTP program includes an ‘anonymous login’
checkbox, make sure this is checked.
When connecting to HyperDeck Studio Mini, you don’t need to enter a username or
password. Simply enter your disk recorder’s IP address in your FTP application’s ‘server’
or ‘host’ field and check an ‘anonymous login’ checkbox if one is available.
Transferring Files
Once connected to HyperDeck Studio Mini you can transfer files as you normally would with
your ftp program. Most ftp applications have a drag and drop interface, but check your
particular application for the appropriate method.
You can transfer any file to and from your HyperDeck Studio Mini, but it’s worth noting that any
files you intend to play back from HyperDeck Studio Mini will need to conform to your
HyperDeck’s supported codecs and resolutions. You can find a list of supported codecs in the
‘Blackmagic HyperDeck Setup’ section of this manual.
TIP You can transfer files over a network while your HyperDeck Studio Mini is
recording. HyperDeck Studio Mini will automatically adjust transfer speeds to make
sure recording is not affected.
36Transferring Files over a Network
To Next Page
Loading...
