Functions:
1. SD/MMC Card input: This is a combination SDMMC card input. Capable of reading cards up to
4GB. Music files must be formatted as MP3 in order to be played via SD/MMC card.
2. USB Input: This is a full size USB2.0 female input. It has a read capacity of 4GB. Music files must
be formatted as MP3 in order to be played via USB
3. Play /Pause/folder : Press this button to start or pause an MP3 track played via USB or SD. Also
use this button to scroll through the folders on your USB drive or SD card.
4. Mode: This button allows you to select between, USB, SD, BT, Or FM Radio for playback.
5. Track repeat: select this button to repeat the track that is currently playing via the built in MP3
player
6. Previous Track/Volume down: Use this button to go back one track or to lower the mp3 volume
7. Next Track/Volume up: Use this button to play the next track or raise the mp3 volume
8. EQ: This button allows you to scroll between the EQ presets
9. XLR MIC In
10. ¼” MIC input
11. Echo effect level: Use this to control the amount of echo effect produced by the MIC.
12. MIC gain level: Use this to adjust the gain level of the connected MIC
13. XLR MIC in
14. ¼” MIC input
15. Echo effect level: Use this to control the amount of echo effect produced by the MIC.
16. MIC gain level: Use this to adjust the gain level of the connected MIC
17. 5 band EQ: Use these to adjust the frequencies produced by the speakers
18. Echo Effect Control: Use these adjustments to modify the echo effect
19. RCA Stereo line inputs: These allow input from source units using L/R stereo RCA connections
20. RCA Stereo line outputs: These provide a stereo line signal output
21. MP3/Line Selector: Use this button to select between the onboard MP3 player or the RCA line
in connections as the audio source.
22. Line/MP3 gain level: This adjusts the output gain of the MP3 player and the line level input
23. Master Volume Control: This controls the overall output of the speakers. This volume control
supersedes all other built in volume controls.
24. Amplifier Heat sink
25. 8ohm speaker out: This allows you to connect an external passive speaker via a speakon
connection.
26. Input Voltage selector: This switch allows the unit to be compatible with 120V and 240V power
sources. Ensure that the correct position is selected for your power source. Improper selection
will severely damage this unit and could cause an electrical fire.
27. Master power switch: Use this switch to power the unit on or off.
28. AC power connection only use supplied AC power cord
To Next Page
Loading...
