EasyManua.ls Logo

Black+Decker BCASCS61B - Page 10

Black+Decker BCASCS61B
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
ENGLISH
(Original instructions)
Wear gloves
Wear hat
Always remove the battery from the appliance
before performing any cleaning or maintenance
.
Beware of ying objects. Keep bystanders
away from the cutting area
R
Do not expose the appliance to rain or high
humidity.
Wear non-slip footwear.
Beware of falling objects.
Electrocution hazard. Keep at least 10m away
from overhead lines.
To ensure continued safe operation, check the
chain tension as described in this manual after
every 10 minutes of use, and adjust back to a
clearance of 3 mm as required. Oil the chain
after every 10 minutes of use.
Direction of rotation of chain
Warning! Do not touch chain at the chip ejec-
tion point.
Directive 2000/14/EC guaranteed sound power.
Additional safety instructions for batteries and
chargers (not supplied)
Batteries (not supplied)
u Never attempt to open for any reason.
u Do not expose the battery to water.
u Do not store in locations where the temperature may
exceed 40 °C.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u Charge only using the charger provided with the tool.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers (not supplied)
u Use your BLACK+DECKER charger only to charge the
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
u Never attempt to charge non-rechargeable batteries.
u Have defective cords replaced immediately.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Chainsaw attachment
2. Chainsaw attachment release button
3. Kick back guard
4. Kick back guard release button
5. Guide bar
6. Saw chain
7. Guide bar cover
Charging a battery (not supplied) (g. A)
BLACK+DECKER chargers are designed to charge
BLACK+DECKER battery packs.
u Plug the charger (9) into an appropriate outlet before
inserting a battery pack (8).
u Insert the battery pack (8) into the charger, making sure
the battery pack is fully seated in the battery slots (Figure
A).
The LED (9a) will ash indicating that the
battery is being charged.
96

Related product manuals