Black+Decker BDT20WTB - Before First Operation

Page 8
BEFORE FIRST OPERATION
1. Grip each side of the bucket and pull to remove the bucket from the
dehumidier (Fig. 4).
2. Check inside the bucket to make sure the oat system is in the correct
position. If not, place the oat in the correct position (Fig. 5).
3. Re-insert the bucket once you have determined the oat system is in the
correct position (Fig. 6)
The oat in the bucket is essential to the “bucket full” system working properly.
Do not remove the oat and make sure the oat can rotate freely.
SET UP & USE
Fig. 4
Fig. 5
Fig. 6