Black+Decker BFSD116B - Page 9

Page 9
ENGLISH
SET UP & USE
OPERATION INSTRUCTIONS
The fan may be operated by the remote control (as shown in FIGURE 8) or by
manual controls located (shown in FIGURE 9). Place the FAN on a stable at surface.
Plug the cord into a 120V A.C. electrical outlet.
TILT ADJUSTING
To adjust the air ow upward or downward, push the grill section lightly to the
desired direction.
HEIGHT ADJUSTING
The height of the fan can be adjusted by loosening the height adjustment ring.
Carefully raise or lower to desired height and re-tighten the height adjustment ring.
REMOTE CONTROL (Fig. 8)
Point the remote control at the body of the fan and press the desired button. The
remote control will work at distances of up to roughly ve meters (16 feet) and an
angle of 30 degrees left and right of the control panel.
1. POWER KEY - Turn the fan on by pressing the “POWER” button; turn the fan
off by pressing the “POWER” button again.
2. SPEED KEY - You can adjust the fan speed to the desired level: low, medium, or
high by pressing “SPEED” continuously.
3. MODE KEY - Pressing the “MODE” button will set the fan into NORMAL,
NATURAL, and SLEEP mode.
4. TIMER KEY - The fan is equipped with a timer that allows you to set its length of
operation
5. OSC KEY - Pressing the “OSC” button will start and stop the oscillation function.
Speed
Mode
OSC
Timer
Fig. 8
PowerSpeed
TimerMode
OSC