Page 21
SET UP & USE
WASHING A LOAD OF LAUNDRY
Operate with cold water only.
Step 1: Power on your washer
Press the ON/OFF button to power your wash on.
Step 2: Load your washer
Before loading your laundry, be sure to take out coins, keys
and other hard objects, and close all zippers to prevent the
clothes from damage.
Sort laundry by fabric type, soil level, color and load size as needed.
Refer to the Fabric Care Chart in the APPENDIX. You can fill the tub
with dry, unfolded clothes ,but DO NOT OVERLOAD the tub. Load
the tub no more than 3/4 full.
To ensure good cleaning results do not overload the tub, especially when washing
heavily soiled loads. Never load the tub more than 3/4 full.
Overloading may reduce washing eciency, cause excess wear, and possibly
cause creasing or wrinkling of items in the load.
NOTE: To add a forgotten item:
1. Press the START/PAUSE button to pause the washer.
2. Wait for the tub to stop turning, then open the door.
3. Add the item, close the door, and then press the START PAUSE button. The cycle
will resume.
Step 3: Add detergent
This washer is designed for high eciency (HE) detergent only.
Add the recommended amount of detergent directly into basket
before starting your washer. the. The normal amount of detergent
to use is 1/4 to 1/2 of the maximum amount recommended by the
detergent manufacturer. Always reduce the amount of detergent
if the load is small or lightly soiled, or if your water is very soft . Never use more than
the maximum amount recommended by the detergent manufacturer.
Never pour any liquid bleach directly onto the load. It can cause fabric damage,
such as weakening of cloth fibers or color loss.
ON/OFF
To Next Page
Loading...
