Page 32 Page 33
ENGLISH ENGLISH
Page 32 Page 33
TROUBLESHOOTING & WARRANTY TROUBLESHOOTING & WARRANTY
ERROR CODE POSSIBLE CAUSE SOLUTIONS
E1 It takes over 30 minutes
to ll water but cannot
achieve its preset
water level.
Check troubleshooting (pg 32) for
washer not lling properly and
water leakage.
E2 It takes over 10 minutes
to drain the water
but the washer is not
completely drained.
Check troubleshooting for Washer
will not drain water.
E3 The top lid is open. Close the lid and press the
ON/OFF button.
E4 The washer runs out of
balance three times.
Redistribute the load.
FABRIC CARE CHART
The following symbols provide garment care direction. The Clothing care labels
include symbols for washing, bleaching, drying and ironing, or dry cleaning when
necessary. The use of symbols ensures consistency among garment manufacturers
of domestic and imported items. Follow care label directions to maximize garment
life and reduce laundering problems.
Water Cycle Special Instructions Warning Symbols for laundering
Water Temperature**
Heat Setting
Iron-Dry or
Steam Temperature
Bleach
Normal
Dryclean
Normal Do Not Wash
Do Not Wring
Do Not Bleach
Do Not Tumble Dry
No Steam (added to iron)
Do Not Iron
Line Dry/
Hang to Dry
Permanent Press / Wrinkle
Resistant / Wrinkle Control
Drip Dry
Gentle/Delicates Dry Flat
Hand Wash
Hot
Any Bleach (when needed)
Tumble Dry Cycle
Only Non-Chlorine (color-safe)
Bleach (when needed)
Permanent Press / Wrinkle
Resistant / Wrinkle Control
Gentle / Delicates
High
Dry Clean
Do Not Dry Clean
Drip Dry
Dry Flat
Line Dry/Hang to Dry
For machine-washable
wool. Loads should be
under 8 pounds.
Medium
Low
High
Medium
Low
Any Heat
No Heat/Air
Warm
Cold
** The number of dots represent appropriate wash water temperatures for various
items. The temperature range for Hot is 105°-125°F/41°-52°C, for Warm
85°-105°F/29°-41°C and for Cold 60°-85°F/16°-29°C.(Wash water temperature must
be a minimum of 60°F/16°C for detergent activation and effective cleaning.)The
clothes washer can
not ensure these temperatures because the actual temperature of the water entering
your washer depends on water heater settings and regional water supply
temperatures.
For example, cold water entering the home in the northern states during winter may
be 40°F/4°C which is too cold for effective cleaning. In this situation, you will need
to adjust the water temperature by selecting a warm setting, adding some hot water
to the MAX FILL line, or using your Washer’s heating option, if available.
To Next Page
Loading...
