Page 24 Page 25
ENGLISH ENGLISH
CARE AND CLEANING
CLEANING AND MAINTENANCE
Cleaning the exterior
Turn off the water faucets after nishing the day’s washing.
This will shut off the water supply to your washer and prevent the unlikely
possibility of damage from escaping water.
Leave the lid open to allow the inside of your washer to dry out.
Use a soft cloth to wipe up all detergent, bleach or other pills as they occur.
Clean the following as recommended:
Control Panel - Clean with a soft, damp cloth. Do not use abrasive powders
or pads. Do not spray cleaners directly onto the panel.
Cleaning the interior
Clean the interior of your washer periodically to remove any dirt, soil, odor, mold,
mildew, or bacterial residue that may remain in your washer as a result of washing
clothes.
Failure to follow these instructions may result in unpleasant conditions,
including odors and/or permanent stains on your washer or laundry .Hard water
deposits may be removed, if needed. Use cleaners labeled “Washer safe”.
Tub clean
Run an Rapid cycle with some bleach every month to clean the tub.
This will also help to remove mold which may occur inside the washer.
Lint lter clean
There is a built-in lint lter in your washer. It can help to collect lint during
washing cycle.
It is suggested to clean the lint lter every 10 cycles.
Take it out and clean the lter with water. Then place it back into the washer.
Pump lter clean
There is a built-in Pump lter located in the back of your washer. It can help to
protect the pump during washing cycle.
It is suggested to clean the lint lter every once every month.
It is suggested to clean the pump lter once every month.
Remove the lter by turning it to the left. Rinse it with water and re-insert it by
turning it to the right.
TROUBLESHOOTING & WARRANTY
BEFORE YOU CALL FOR SERVICE
IF THE UNIT FAILS TO OPERATE:
A) Check to make sure that the unit is plugged in securely. If it is not, remove the
plug from the outlet, wait 10 seconds and plug it in again securely.
B) Check for a blown circuit fuse or a tripped main circuit breaker. If these seem to
be operating properly, test the outlet with another appliance.
IF NONE OF THE ABOVE SOLVES THE PROBLEM, CONTACT OUR CUSTOMER
SATISFACTION CENTER. DO NOT TRY TO ADJUST OR REPAIR YOURSELF.
IMPORTANT
DO NOT RETURN THIS PRODUCT TO THE STORE
If you have a problem with this product, please contact the
W Appliance Co. Customer Satisfaction Center at
844-299-0879 or service@equitybrands.com.
DATED PROOF OF PURCHASE, MODEL # AND SERIAL #
REQUIRED FOR WARRANTY SERVICE.
Press down to remove snap back into
place to re-insert
To Next Page
Loading...
