9
ENGLISH
(Original instructions)
Warning! High pressure cleaners shall
not be used by children or untrained
personnel.
Warning! High pressure hoses,
fittings and couplings are important
for the safety of the machine. Use
only hoses, fittings and couplings
recommended by the manufacturer.
Warning! To ensure machine safety,
use only original spare parts from the
manufacturer or approved by the
manufacturer.
Warning! Water that has flowed
through backflow preventers is
considered to be nonpotable.
Warning! Do not use the machine if a
supply cord or important parts of the
machine are damaged, e.g. safety
devices, high pressure hoses, trigger gun.
Warning! Incorrect fuels shall not be
used as they may prove hazardous.
Warning! Do not use near people
except that they use protective
clothing.
4. Service
a. Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
5. Electrical safety
Your tool is double insulated;
therefore no earth wire is required.
Always check that the main voltage
corresponds to the voltage on the
rating plate.
Warning! If the power cord is
damaged, it must be replaced by the
manufacturer, authorized
BLACK+DECKER Service Center or
an equally qualified person in order
to avoid damage or injury. If the
power cord is replaced by an equally
qualified person, but not authorized
by BLACK+DECKER, the warranty
will not be valid.
Warning! Always switch o the
mains disconnecting switch when
leaving the machine unattended.
6. Labels on tool
The label on your tool may include the
following symbols:
Warning! Safety signs. Comply with
the instructions provided by the
safety signs ted to the appliance.
Check that they are present and legible;
otherwise, replacements in the original
positions.
TECHNICAL INFORMATION
ENVISAGED USE
This appliance has been designed for
individual use for the cleaning of vehicles,
machines, boats, masonry, etc, to remove
stubborn dirt using clean water and
biodegradable chemical detergents.
Vehicle engines may be washed only if the
dirty water is disposed of as per regulations
in force.
• Intake water temperature: See data plate
on the appliance.
• Intake water pressure: Below 10 bar.
• Operating ambient temperature: Above
0°C. The machine complies with the IEC.
OPERATOR
The symbol on the front cover identifies the
appliance’s intended operator (professional
or non-professional).
Read
instructions
manual
Poisoning
hazard
Injury
hazard
Explosion
hazard
Electric shock
and short
circuit hazard
Short circuit
hazard
Danger of
being beaten
by objects that
bounce
Use eye
protection
Wear proper
clothing
...... Class II
Construction
.... Safety Alert
Symbol
V ........ Volts
A ........ Amperes
Hz ....... Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
Danger sign, warns users not to direct the water jet at people,
animals, elec- trical equipment or the product itself.
Not connect to potable water.
To Next Page
Loading...
