EasyManua.ls Logo

Black+Decker KX3300 - After Use; Inspection and Repairs; Labels

Black+Decker KX3300
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
ENGLISH
(Original instructions)
7
ENGLISH
(Original instructions)
u The hose has a double wall to reduce
the surface temperature.
u Your unit is tted with an overheat
protection device (thermal cut-out)
which will operate if the unit boils dry.
Switch off, allow the unit to cool for 2
minutes and rell with water, preferably
hot. The cut-out will automatically reset
and steam will be produced within 5 to
10 minutes.
u You should not allow the unit to be
tilted as this may result in the overheat
protection (thermal cut-out) operating
leading to excessive re-set times.
u In the event of the steam pipe becom-
ing blocked and excess pressure is
evident, remove the plug from the
electric supply. Do not try to open
the ller cap until the unit has been
allowed to cool for 2 minutes otherwise
an interlock device will be activated
inside the cap. The interlock device will
reset itself once the unit has cooled
thus allowing the cap to be removed.
After use
u Switch off and remove the plug from
the socket before leaving the appli-
ance unattended and before changing,
cleaning or inspecting any parts of the
appliance.
u When not in use, the appliance should
be stored in a dry place. Children
should not have access to stored ap-
pliances.
Inspection and repairs
u Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may af-
fect its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
u Before use, check the power supply
cord for signs of damage, ageing and
wear.
u Do not use the appliance if the power
supply cord or mains plug is damaged
or defective.
u If the power supply cord or mains plug
is damaged or defective it must be re-
paired by an authorised repair agent in
order to avoid a hazard. Do not cut the
power supply cord and do not attempt
to repair it yourself.
u Never attempt to remove or replace
any parts other than those specied in
this manual.
Labels
The following safety labels are found on
your appliance along with the date code.
Never pull the unit by the
electric cable.
Never pull the unit by the
hose.
Never use the steam plate
directly above your head as
hot water may drip.