15
TROUBLESHOOTING
If your Pole Saw does not operate correctly check the following:
Problem Possible Cause Possible Solution
Tool will not
start.
Unit will not
charge.
Bar / chain
overheated.
Battery not
installed properly.
Battery not charged.
Lock-out button not
actuated.
Pole connections not
properly tightened.
Battery not inserted
into charger.
Chain too tight.
Lubrication
needed.
Check battery installation.
Check battery charging
requirements.
Pull back on lock button/
actuate trigger.
Refer to instruction manual
for pole connections.
Insert battery into charger
until green LED appears.
Charge up to 8 hours if
battery is totally drained.
Refer to section on
adjusting chain tension.
Refer to sections for chain
oiling application.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the LI-ION battery (or battery pack)
indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid
by Black+Decker.
RBRC™ in cooperation with Black+Decker and other battery users,
has established programs in the United States to facilitate the
collection of spent LI-ION batteries. Help protect our environment and
conserve natural resources by returning the spent LI-ION battery to
an authorized Black+Decker service center or to your local retailer
for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery.
RBRC™ is a
registered trademark of the Rechargeable Battery Recycling Corporation.
SERVICE INFORMATION
All Black+Decker Service Centers are staffed with trained personnel
to provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory
replacement parts, contact the Black+Decker location nearest you.
To find your local service location, call: 1-800-544-6986 or visit
www.blackanddecker.com.
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
For assistance, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the
Black+Decker help line at 1-800-544-6986.
Unit runs but
does not cut.
Chain installed
backwards.
Refer to sections for
installing and removing
chain.
Poor cut
quality.
Chain tension set
incorrectly.
Chain needs
replacement.
Refer to section on
adjusting chain tension.
Note: Excessive tension
leads to excessive wear
and reduction in life of
bar & chain. Lubricate
use. Refer to section for
installation of chain.
Chain is
loose.
Chain tension set
incorrectly.
Refer to section for chain
tensioning.
To Next Page
Loading...
