To Next PageTo Next Page
Need help?Do you have a question about the Blackstar Amplification DEPT.10 AMPED 3 and is the answer not in the manual?
General| Brand | Blackstar Amplification |
|---|---|
| Model | DEPT.10 AMPED 3 |
| Category | Amplifier |
| Language | English |
Controls the amplifier's channel selection and mode switching.
Selects specific channel voices for clean, crunch, and overdrive.
Adjusts the amount of overdrive or distortion in the sound.
Controls the level of low-end frequencies in the tone.
Adjusts the level of mid-range frequencies for tone body.
Controls the level of high frequencies for tone brightness.
Allows selection of tonal signature between American and British characteristics.
Controls the preamp/channel volume, affecting tone and compression.
Controls signal level boost and its position in the signal chain.
Toggles the Boost effect on/off and switches between Manual/Patch modes.
Adjusts the amount of reverb and selects reverb type (Dark/Light).
Toggles the Reverb effect on/off and activates the 'Freeze' effect.
Selects power valve response (EL84, EL34, 6L6) for amp character.
Controls the overall treble and high-end response of the power amp stage.
Sets the overall volume of the amplifier, interacting with preamp volume for distortion.
Selects the amplifier's output power setting (1W, 20W, 100W).
Indicates mismatches between front panel controls and stored patch values.
Connects the detachable IEC mains cable for power supply.
Turns the amplifier unit on and off.
Guitar input jack for connecting the instrument.
Outputs the signal to external effects units for processing.
Receives processed signal from external effects units.
Sets the FX Loop level for compatibility with external gear (+4dBu or -10dBV).
Outputs the processed signal to another amplifier or device.
Connects to guitar speaker cabinets (8 Ohm and 16 Ohm).
Provides two isolated 9V DC outputs for powering external pedals.
Connects to computer for USB digital audio and Architect software.
Processed guitar sound with power amp/cab emulation (left channel).
Processed guitar sound with power amp/cab emulation (right channel).
Preamp signal before reverb/emulation, ideal for external plugins.
Direct signal from guitar, ideal for reamping.
Receives MIDI messages from external devices for control.
Passes received MIDI messages to other connected devices.
Balanced XLR output for professional audio interface connection.
Stereo 1/4" TRS output for recording devices, mixers, or headphones.
Allows crafting and controlling virtual cabinet tone via a dedicated strip.
Selects virtual speaker cabinets or DI for direct power amp output.
Mic up virtual cabinets with a choice of 6 industry standard microphones.
Selects room ambience type for virtual cabinet sound.
Adjusts stereo width of room ambience using micing techniques.
Balances cab and room levels using channel faders and mute/solo.
Applies EQ shaping to cab and mic combinations, with presets available.
Patches stored on the amplifier, recallable via footswitch or MIDI.
Factory presets included with Architect software for tone starting.
Patches saved on your computer, accessible via the software.
Adjusts MIDI channel, FX Loop, and Reverb settings within the software.
Displays information about the amplifier.
Restores factory patches and settings using Blackstar Architect software.
