American characteristic with a tight bottom end and more aggressive middle, and
fully CW has a British characteristic which is more ‘woody’ and less aggressive.
11. Headphones & Speaker Emulated Output
This output emulates the tonal characteristics of a guitar speaker cabinet and
provides a natural valve overdrive tone for connection to a recording device or mixing
desk, and for use with headphones. Always use a good quality screened guitar lead.
12. Cabinet Switch
The switch enables you to select either a 4x12 closed back or a 1x12 open back
cabinet emulation for the Speaker Emulated Output.
13. Power Indicator Light
The power indicator will light when the amplifier is switched on.
14. Standby
This switch applies the H.T. (High Tension) voltage required to produce sound.
Always turn this switch on at least 30 seconds after the Power switch (15). During
short breaks in playing use just this switch to turn ‘off’ and ‘on’ the amplifier’s output.
15. Power
This switch is used to turn the amplifier on and off. You should always turn this switch
on before turning on the Standby switch (14).
English
9
To Next Page
Loading...
