534758 534759
534765
1818
Screw Shaft 3x36mm
Li-ion battey 9.6V 800mAh
390 Motor w/PinionScrew Shaft 3x31mm
USB Charging Cable
540079
TROUBLESHOOTING
Problem
Short run time • Battery damaged/not charged
• Motor dirty or brushes worn
• Check/change battery
• Check/clean/replace
Sluggish action • Motor dirty or brushes worn
• Bind in drivetrain
• Vehicle battery is not charged
• Check/clean/replace
• Clean/adjust
• Replace/recharge
Do not operate • Transmitter batteries low
• Transmitter powered off
• Vehicle battery is not charged
• Replace/recharge
• Power On
• Replace/recharge
Possible Cause Solution
Poor range • Low transmitter batteries
• Receiver antenna damaged
• Replace/recharge
• Check/repair/replace
The system will not
Connect
• Transmitter and receiver too near each other
• Transmitter and receiver too near large
metal objects (vehicles, etc.)
• Receiver accidentally put in bind mode so
receiver is no longer bound
• Move transmitter 8–12 feet
(2.4–3.6m) from receiver
• Move away from large metal objects
(vehicles, etc.)
• Rebind transmitter and receiver
The receiver quits responding
During operation
• Low battery voltage
• Completely recharge battery
Receiver loses its bind • Transmitter accidentally put in bind mode,
ending bind to receiver
• Bind transmitter to receiver
534760
534767
2.4G Receiver PCB
To Next Page
Loading...
