EasyManuals Logo

Blagdon Powersafe User Manual

Blagdon Powersafe
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
THE POWERSAFE GUIDE TO
OUTDOOR TWIN SOCKET
Congratulations on buying a Blagdon Powersafe outdoor twin socket. This easy to install
system has been designed with numerous advanced features to help you safely enjoy the
convenience of outdoor sockets in your garden. Please take the time to read this guide
carefully to ensure that you get the maximum safety and benefits from this product.
IMPORTANT: Please attach proof of purchase to this manual and file in a safe place.
GETTING TO KNOW YOUR POWERSAFE OUTDOOR TWIN SOCKET WIRING & ASSEMBLY
TECHNICAL SPECIFICATION
IMPORTANT: If this product is installed using a Blagdon Powersafe armoured garden power supply fitted
with a flexible lead to a three pin plug, in conjunction with a circuit breaker as recommended in the
installation guide. It would not therefore be deemed to be a permanent part of the house wiring and
would not fall within the scope of Part P of the building regulations. However if the product is wired
directly into a fixed wiring spur, it will fall under part P of the building regulations and must be installed by
a qualified electrician or in consultation with a building control officer.
MAXIMUM LOAD PER OUTLET
POWER STATUS INDICATOR LIGHT
Voltage 220-240V
Hertz 50/60Hz
Safety IP56 CE
Cable size 4-9mm
Maximum power per outlet 2200w
combined three line outs 2200w
INSTALLATION
SOCKETBOX MOUNTING
The Socketbox should be situated
in a site that is protected from:
Flooding
Extreme heat
Physical damage
Tampering by adults
and children
Powersafe circuit breaker
plugged into standard
household 3-pin socket.
••
Hole drilled through door/
window frame or wall &
sealed with weatherproof putty.
Pre-wired plug &
socket adaptor &
fixing bracket.
Metal sheathed armoured
cable can be buried, fixed to
fence, or run above ground.
Connects armoured
cable to pre-wired
50cm rubber cable.
Powersafe Remote
Control Socket Box
(triple outlet).
RCD
Circuit
Breaker
Mains Plug
Mains Socket
Cable cleats
Socket
Bracket 1
Plug
Above Ground
Buried cable
marking tape
50cm
30cm
Min
Hidden through
shrubs and plants
30cm
Min
40cm
Max
Twin
Socket Box
Power to appliances
from socketbox
Socket
Bracket 2
Plug
Below Ground
IMPORTANT: IT IS ESSENTIAL THAT THE INSTRUCTIONS ARE FOLLOWED FULLY TO ENSURE
THAT THE PRODUCT IS BOTH WEATHERPROOF AND SAFE TO USE.
WARNING: A Residual Current Device (RCD), also
known as the Residual Current Circuit Breaker (RCCB),
with a tripping current not exceeding 30mA must be
installed in the supply circuit. A means of disconnection
from the supply having a contact separation of at least
3mm in all poles must be incorporated in the wiring.
CABLE PREPARATION
20mm
5mm
IMPORTANT:
Switch off and isolate the power
supply and ensure that all parts are clean and
dry before fitting.
The Socket Box has been designed to work with circular
smooth sheathed cables only. The cable glands supplied
allow fitting of cables between 4mm - 9mm diameter.
Use the smallest suitable gland size.
INSTALLATION GUIDE: Shown using a Powersafe Armoured Garden Power supply and plug in RCD (sold separately).
SPARES/ACCESSORIES
PART DESCRIPTION SPARE
Fixing bracket 1040389
Fixing bracket screws & plug set 1040396
10 amp fuse 1050692
Powersafe Garden Power Spike 1050272
Rubber Seals Kit 1050715
ELECTRICAL STANDARDS STATE THAT:
ALL OUTDOOR POWER SUPPLIES MUST BE PROTECTED
BY A CIRCUIT BREAKER.
ALL OUTDOOR ELECTRICAL COMPONENTS MUST COMPLY
WITH OUTDOOR WEATHERPROOF SAFETY STANDARDS.
ALL POWER SUPPLIES ACROSS THE GARDEN MUST BE
CARRIED BY METAL SHEATHED ARMOURED CABLE.
IF BURIED, WARNING TAPE MUST BE APPLIED.
You can take power to your pond/garden using a Blagdon
Powersafe Armoured Garden Power Supply and plug in RCD.
This provides safe, legal and easy DIY power to your pond or
garden. Other garden power products are available in the
Blagdon Powersafe range.
The Powersafe socket box is supplied with a mounting
bracket, four screws and wall plugs for convenient
wall or post mounting, contained within this carton.
If a suitable wall or post are not available it is recommended that a
Powersafe garden power spike is purchased (see Spares/Accessories).
This allows for convenient and safe placement of all of the Powersafe
range of switch and socket boxes. It is also ideal for installations away
from a wall, as it prevents damage from splashing and flooding whilst
conforming to electrical safety standards recommended 30cm minimum
ground clearance for outdoor power installations.
SLIDES INTO
MOUNTING
BRACKET
POWERSAFE
PRODUCT
57CM
HIGH
POLE
25CM SPIKE
INTO GROUND
MOUNTING
BRACKETS x2
POWERSAFE GARDEN POWER SPIKE
(SOLD SEPARATELY)
GREEN LIGHT
POWER ON
NO LIGHT
POWER OFF/
FUSE HAS
BLOWN
FUSE
10AMP SPARE FUSE
LINE OUT 1
MAX - 2200W
LINE OUT 2
MAX - 2200W
LINE OUT 3
MAX - 2200W
LINE IN: 230V
10A (FUSED)
2200W (MAX)
INDICATOR
EXTRA SAFE
IP56 Weatherproof connecters
Maximum load fuse protected
LED Power supply active indicator
SIMPLE TO USE AND INSTALL
Easy to replace pop out fuse (spare included)
Integrated wall or post mounting bracket
Plug and socket power link cable provided
EASY, SAFE, SIMPLE &
FLEXIBLE GARDEN POWER
POWERSAFE
TWIN SOCKET
TRIPLE 2.2KW OUTLETS
2x Three pin sockets
1x Plug and socket
outlet/power link
COMPATIBLE
WITH ANY
POWERSAFE
PRODUCT
Flexible linking
system option
Power outlets
to pond/garden
Additional
mains outlet
or 30cm
mains link
cable
Mains
power in
ENJOY THE CONVENIENCE OF OUTDOOR SOCKETS IN YOUR GARDEN
EASY, SAFE, SIMPLE &
FLEXIBLE GARDEN POWER
OUTDOOR TWIN SOCKET
Twin_Socket_Instructions_AW 11/5/09 10:43 Page 1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Blagdon Powersafe and is the answer not in the manual?

Blagdon Powersafe Specifications

General IconGeneral
BrandBlagdon
ModelPowersafe
CategoryAccessories
LanguageEnglish

Related product manuals