Need help?Do you have a question about the BLAM RELAX RA 704 DSP PRO and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Class | D |
| Power @ 4 Ohms | 70W x 4 |
| Power @ 2 Ohms | 100W x 4 |
| Power @ 4 Ohms Bridged | 200W x 2 |
| DSP | Yes |
| Frequency Response | 10 Hz - 22 kHz |
| Crossover Frequency | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | >90dB |
Detailed view of the amplifier's terminal panel with numbered connectors and indicators.
Information regarding the power input terminal and the integrated fuse for the amplifier.
Adjusting 7 frequency bands with Q-factor for sound customization and tone shaping.
Configuring high pass, low pass, and bandpass filters for each audio output channel.
Adjusting speaker delays to optimize sound stage perception and listener experience.
Option to disconnect or invert speaker phase for optimal sound reproduction.
Applying specific treatments for an enveloping and immersive soundscape.
Dynamic bass boost setting below 80Hz for enhanced low-frequency listening.
Saving settings to the amplifier or phone for easy recall and management.
Connecting external amplifiers for subwoofers via the designated terminal.
Utilizing front/rear channels for woofers/tweeters with an optional dedicated cable.
To Next Page
