Blastrac BMP-215 E/B - User Manual

Questions and Answers

M
Mary BradyAug 12, 2025
Why is my Blastrac Lawn and Garden Equipment vibrating excessively and making unusual noises?
- M
  Monica HeathAug 12, 2025
  If your Blastrac Lawn and Garden Equipment is experiencing excessive vibration or unusual noises, several factors could be the cause. It might be due to an imbalance from worn or broken tools, in which case you should replace all worn or broken parts. Another potential cause is a defective bearing; inspect the bearing on the axle drive shaft and replace it if needed. The issue could also stem from incorrect belt tension, so check the belt's tension and replace it if necessary. Finally, a defective motor could be the source of the problem, requiring a motor replacement.
A
Ashley ThompsonAug 27, 2025
Why does my Blastrac BMP-215 E/B Lawn and Garden Equipment have reduced scarifying performance?
- D
  David HarveyAug 27, 2025
  If your Blastrac Lawn and Garden Equipment has reduced or no scarifying performance, it could be because the tools have reached their maximum permissible wear. Replace the worn parts. Another possible reason is using inappropriate tools for the application; replace them with the correct ones for the surface you're working on.
H
Heather ChavezSep 3, 2025
What to do if the motor of my Blastrac BMP-215 E/B Lawn and Garden Equipment triggers while running?
- P
  Patrick MathewsSep 3, 2025
  If the motor of your Blastrac Lawn and Garden Equipment triggers while running, it may be due to the motor protections switch being activated by an overload; try reducing the additional load. Alternatively, the motor itself might have a defect, so you should check it.
E
Eric KirbySep 10, 2025
What to do if the motor of my Blastrac BMP-215 E/B does not switch on?
- G
  Gabriella WashingtonSep 12, 2025
  If the motor of your Blastrac Lawn and Garden Equipment isn't switching on, it could be due to a missed phase in the mains power supply. Check the power supply and try again. Alternatively, a defective component could be the reason. In this case, identify and replace the defective component.