16
5.5 Start up machine
Before start-up the operating personnel must be familiar with the safety regulations given in this
manual.
Before switching on the machine make sure that no-one can be endangered when the machine starts
up.
Persons who are not operating the machine must not be permitted to stay in the surrounding area of
at least 5 meter from the machine.
1. Selection switch must be on ‘0’ position
2. Turn speed control to slowest position.
3. Plug in the main plug.
4. Turn the selection switch to ‘2’ position.
5. Engage forward or reverse switch.
6. Increase speed control to desired speed.
The frequency drive has been factory set, do not change any setting of the frequency drive.
Do not lock the levers for wheel drive into a permanent position. If the operator would lose control or be
disabled, the machine continues to operate.
WARNING! If there is a power failure or the machine stops for any reason, always put the selection switch
back to ‘0’!
NEVER leave the machine when the selection switch is in position ‘1’ or ‘2’! When the power failure is rectified
and the machine is still in position ‘2’, the machine will start vibrating automatically!
NOTE! When you engage the machine in reverse, the machine will travel with the highest speed.
To Next Page