USING YOUR APPLIANCE
CORDED/CORDLESS IRONING
For cordless ironing the iron should be placed into its base between
ironing items.
When placing the iron into the base, make sure to have a rm grip
on the handle and t it smoothly into the slots. Once placed into the
base the iron will begin to heat to the setting you have selected.
The indicator light on the base will illuminate to show the iron is
heating. It only takes a few seconds for the iron to heat in between
each session of use.
When ironing with the base attached make sure the iron is locked
to the base. To do this slide the locking tab to the locked padlock
position. To unlock simply reverse the procedure, always taking care
if the iron is still hot.
FILLING THE TANK WITH WATER
CAUTION! Before lling the tank with water make sure the
appliance is unplugged
1. Remove the iron from the charging base before lling (or
emptying) with water. Set the steam control to 'O' position in
order to avoid the water leakage.
2. Fill the lling cup with water. Hold the iron in a tilted position
and pour the water into the water tank to the maximum level.
3. Fill the iron with normal tap water when using it
for the rst time
4. For relling, you can also use tap water. However, if the
water is very hard, it is advisable to use distilled water.
5. Do not put vinegar, starch, chemically, descaled water
or de-scaling agents in the water reservoir
SETTING THE TEMPERATURE
1. Stand the iron on its end
2. Insert the mains plug into the wall socket
3. Set the temperature control to the correct ironing temperature
4. After the temperature light rst has gone out and has come on again, you may start ironing
5. The temperature light will come on from time to time during ironing
6. If you set the temperature control to a lower setting after ironing at a high temperature, please
allow time for the iron to cool. This is to prevent scorching on your garment.
6
To Next Page
Loading...
Need help?
General
