1. Body
2. Water tank
3. On/off switch with humidifying
intensity control
4. Filter with valve
5. Water-mist outlet
6. Aromatherapy attachment
USING THE AIR HUMIDIFIER
Remove the water tank (2) from the device body (1), unscrew the filter valve (4), and fill the tank (2)
with water. Tighten the water tank (2) along with the filter (4). Place the water tank (2) in the body of
the device (1). Turn the switch (3) to the right and set the desired humidification intensity. To stop the
device operation, turn the switch (3) to the left.
THE AROMATHERAPY FUNCTION
To use the aromatherapy function, follow these instructions.
1. Take out the aromatherapy attachment (6).
2. Apply a few drops of water-soluble aroma oil (for use in humidifiers) on the sponge.
3. Put the aromatherapy attachment in the right place. The aroma will begin to release when the
humidifier is switched on.
4. When you want to stop the aromatherapy, or the appliance will be unused for some time, remove
the sponge from the aromatherapy attachment and clean it.
CLEANING AND MAINTENANCE
Turn off the device and unplug it.
Remove the water tank and empty it. Then wash it and remove all dirt and sediment from it.
Dry the water tank.
The transmitter and the internal water tank should be regularly desalinated. It is recommended to use
water with the addition of citric acid or vinegar.
Do not immerse the device in water.
The humidifier uses a resin filter which reduces the hardness of the water. It is recommended to replace
it every 3-6 months (depending on the hardness of the water). Recommended filter:
the Blaupunkt ACC001.
6
AHS301
To Next Page
Loading...
Need help?
General
