INSTRUCTION SCHEDULING BLAUPUNKT BLUEBOT
How do I program a time schedule?
You can only program Bluebot when it is switched on or charging. Set
Bluebot’s clock: Press the ‘PLAN’ button on Bluebot (located right above the text
on the robot). Four LEDs will light up (HOME, ZIG-ZAG, PLAN and the ’ ‘ on/off
button). You can now set the time, starting with the hour of the day. Press
‘HOME’ to go increase numbers and ‘ZIG-ZAG’ to lower numbers. When the
hour is set, press the ’ ‘. You can now set the minutes. Adjust the numbers
using the same buttons. Pressing the ‘PLAN’ button will cancel the procedure.
Once the time is set you can program when Bluebot should start its cleaning
routine. To do so, press and hold the ‘PLAN’ button for 3 seconds. Adjust the
time, again using the ‘HOME’, ‘ZIG-ZAG’ and ’ ‘buttons. If you want Bluebot to
abandon its automatic cleaning schedule, set the scheduled time “PLAN” to
00:00.
To Next Page
Need help?
General
