4
5. Operation
5.1. Introduction
This insect killer uses an LED to attract ying insects. The fan will suck these insects into the container and dry
them. This insect killer does not produce any noisy electric shocks nor does it emit any toxins, smoke, scent or
radiation.
This insect killer is designed to be used indoors (bedroom, living room).
Keep the insect killer working for more than 48hours at rst use. Do not open the container during use. Make
sure the insects are dried to death to prevent them from escaping.
Keep the insect killer working for 3hours before going to sleep. Make sure to keep windows and doors closed.
5.2. How to Use
1. Connect the insect killer to the power source. Install the insect killer in a dry location on a stable and non-
slippery surface.
2. Press the on-o button to switch on the appliance.
3. Press AUTO to switch on the automatic mode. The appliance will automatically switch on or o according to
the daylight condition.
4. Press the timer button to set the timer.
5hà8hà12hàtimeroà5h
5. Adjust the brightness of the LED with the light intensity button.
6. Press the on-o button to switch o the insect killer. Disconnect from the power supply after use.
Choose either the auto or timer mode as you cannot use them simultaneously.
For best results, turn o other light sources and prevent from installing the appliance in the draught.
6. Troubleshooting
Problem Reason Possible solution
Appliance does not start
Power supply not connected well Reconnect the power supply
On-o button not pressed Press the on-o button
BP-GIKLED11.indd 4 11/12/2018 13:25:52
To Next Page
Loading...
