19
INITIAL SETUP (CONT.)
LCN SWITCH: to set your TV with logical program numbers, which is used to sort
and group programs. ON (recommended)
Make sure to select “SCAN” to auto tune your TV to search for DTV channels,
CAUTION - Selecting ATV will not work for Australia.
NOTE: Please make sure Antenna (RF) cable is plugged into the ANT IN port located on back
of TV. (refer to page 11 TV ports - #10).
TV SOURCE (INPUT) for Tuning your TV
MAKE SURE to only select DTV as a TV Source. DO NOT select ATV.
Selecting anything else for Australia will not work, as ATV no longer exists.
Select the TimeZone you are using the device in with the directional buttons.
To Next Page
Loading...
