To Next PageTo Next PageHow to troubleshoot no power issue on Blaupunkt CDC-RF6IR?
If the Blaupunkt Modulator has no power, it might be due to a blown fuse. Replace it with a fuse of the same type and rating as the original. If it blows again, it is recommended to consult with your dealer. Another possible cause is improper connection, so check all connections to ensure they are correctly set up.
Why is there noise during playback on my Blaupunkt Modulator?
If you are experiencing noise during playback or intermittent sound with your Blaupunkt Modulator, the disc might have large scratches or be warped. Compare the sound with another disc; if the second disc sounds acceptable, the first disc is likely defective. Another cause might be an extremely dirty disc, so try cleaning it. Also, check if the transit screws are still in place and remove the 3 screws on the bottom of the unit and try again.
What to do if the Blaupunkt CDC-RF6IR wireless remote control does not work?
If the wireless remote control for your Blaupunkt Modulator isn't working, the battery might be dead. Try replacing it. Another possibility is that the commander IR sensor or the remote control's lens is dirty, so clean the sensor and/or the control’s lens.
Why is there no sound coming from my Blaupunkt Modulator?
If there is no sound from your Blaupunkt Modulator, the issue might be due to an improper connection. Ensure that all connections are correctly set up.
How to fix no sound in two-speaker system with Blaupunkt Modulator?
If you have no sound in a two-speaker system with your Blaupunkt Modulator, the fader might be set to non-existent speakers. Set the fader to the center position to determine if the speakers are wired for front or rear setting.
What to do if magazine cannot be installed in Blaupunkt CDC-RF6IR?
If the magazine cannot be installed in your Blaupunkt Modulator, it might be because you are trying to insert it improperly. Ensure you insert it in the proper direction.
Why won't selected disc play on my Blaupunkt CDC-RF6IR?
If a selected disc does not play on your Blaupunkt Modulator, the disc might be loaded incorrectly. Load the disc with the play side facing up (printed side should face down).
General| Type | FM Modulator |
|---|---|
| Power supply | 12V DC |
| Input | Audio |
| Output | FM signal |
| Frequency Range | 87.5-108 MHz |
Button to turn the unit on, pause, or resume play.
Button to select the desired disc.
Button to select the desired track or perform audible cue/review.
Button to turn the unit off.
