ADJUST VOLUME
While listening, press + VOLUME – to adjust volume.
ADJUST DISPLAY BRIGHTNESS
Press DIMMER repeatedly to select high or low brightness levels.
BATTERY BACK-UP
(For Temporary Time Storage Only)
Install 2 x LR06, AA or EU-3 battery (not included) according to polarity shown inside the battery
compartment. In the event of a power interruption, your set will not work normally from the mains
supply but there is now the advantage
that your clock will continue to work. The clock display will not light up, as the clock time will be
held in the memory. This also enables you to move the set from place to place without re-setting
the clock every time. The battery
back-up system is only meant to be used from short temporary power interruption. For longer
durations, the battery may become exhausted or there may be some deviation in accuracy. When
the battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to
take advantage of the battery back-up system, your set will work normally without a battery.
However, if disconnected from the mains, the clock figures will flash when the mains are re-
connected and you must re-set the clock as described in the Electronic Clock Operation paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don’t throw used
batteries in dustbin. Please contact your retailer in order to protect the environment.
Attention should be drawn to the environmental aspects of battery disposal. Electrical products
should not be disposal of with household waste. Please recycle where facilities exist. Check with
your Local Authority of retailer for recycling device. (Batteries pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or the like.
SPECIFICATION
Power Source: AC 230V~50Hz
Tuner Range: FM 87.5-108.0MHz
Power Consumption: 3.5 Watt
CR5WH
8
To Next Page
Loading...
