Blaupunkt CR7BK - Installation and Basic Settings; AC;DC Adapter Installation; Backup Battery Installation; Setting Time and Snooze Duration

CR7BK
6
INSTALLATION
Plug the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the back
of the unit. Your clock radio is ready to work for you.
BACKUP BATTERY INSTALLATION
Your clock radio requires one CR2032 lithium battery (not included) to provide backup
power to the clock in the event of a temporary power interruption.
1. Place your unit face down on a flat surface.
2. Slide and remove the battery cover at the bottom of your unit.
3. Insert one new CR2032 lithium battery into the battery compartment with the “+”
side facing up as indicated.
4. Replace the battery cover.
If AC power is interrupted, the LED display will go off and both the radio and the alarm will
not function. The backup battery will keep the time and all settings of your unit. Make sure
a fresh CR2032 lithium battery is used. A fresh CR2032 battery could backup your clock
continuously for around 3 days.
SETTING TIME, 12/24HR TIME AND THE SNOOZE DURATION
1. Press SET once, the hour digits flash. Press
or to set the current hour
(hold to advance rapidly).
2. Press SET again, the minute digits flash. Press
or to set minutes. (hold to
advance rapidly).
3. Press SET again, the display shows “24H” and flashes. Press
or to select
“12H” or “24H” time format.
4. Press SET again, the display shows “05” and flashes. Press
or to select your
snooze time from 5 to 60 minutes.
5. Press SET again or if no key is pressed in approx. 10 seconds to exit the setting
mode.
Note: when 12-hour time format is selected, the P (PM) LED will appear at the lower
middle part of the time display to indicate the afternoon time; there is no AM indicator.
SETTING THE ALARMS
1. Press AL 1.2 once, the A1 LED and the hour digits flash. Press
or to set
the alarm 1 hour. (hold to advance rapidly).
2. Press AL 1.2 again to adjust minutes. Press
or to set the alarm 1
minutes. (hold to advance rapidly).
3. Press AL 1.2 again, LED displays “OFF” (alarm off). To select wake to sound
sources, press
or to select :-
rd = wake-by-radio
bu = wake-by-buzzer
OFF = alarm off
ENGLISH