WEAR PERSONAL PROTECTIVE EQUIPMENT
• Wear safety glasses according to En166
• Use protective masks in accordance with En149
• Use other types of proper personal protective equipment, depending on the type of work involved.
Device description:
Intended use:
The device is used for heating or pre-heating plastic materials,
for welding heat-shrinkable materials, for heating and removing paint coatings,
as well as for other works requiring a stream of hot air.
Before each start-up:
1. Check that the power cord is in good condition.
2. Check that the ventilation grilles of the device are not blocked/covered.
3. If necessary, blow with compressed air.
5
Read the user manual.
Use ear protection
Wear protective glovesGeneral warning
Wear protective clothing
Wear a protective mask
Wear safety glasses
Fire hazard
Wear respiratory protection
Electric shock hazard
1. On/off switch, blowing control.
2. Handle.
3. Hot air outlet.
4. Ventilation grille.
Device is compliant with EU directives:
-Low voltage directive (LVD)
-Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
HG2010
To Next Page