Notes:
a. An extension cable for USB connection playing is not recommended, because that will impact the audio
signal transfer and create noise output issue.
b. The unit only can detect and play the music when the USB or microSD card installed.
Bluetooth operation
The unit includes Bluetooth function which allows you to do the audio streaming playback with other
Bluetooth device.
1. Press the “ MODE” or “ M” button enter to the Bluetooth mode. It will have a notice sound come out from
speaker when you enter the Bluetooth model successful, which means the unit is ready for pairing.
2. Turn on or enable the Bluetooth function on your Bluetooth device ( smart phone etc., detail reference
your device operation manual), and scan the available Bluetooth device.
3. Please check the available Bluetooth list of your device, and select “ BP HR10BT” in order to start the
pairing( input “0000” in case of a POP password required). There will have a notice sound come out from
the radio after pairing successfully.
4. Select and play the music from your Bluetooth device, then the sound will output from the radio.
5. You can press the Previous/Next/Play/pause button to get the relative operation.
6. Press and hold the Play/Pause button 3 seconds can disconnect the pairing between the current
Bluetooth device and unit. And the unit will ready to pair with other Bluetooth device.
Phone call hands free operation: When there have an incoming call in Bluetooth playback mode, press the
Play/Pause key on front panel can pick up the call, and press the Play/Pause button again can end the call.
Please kindly put your mouth talk and next to the textile speaker grill because the microphone was built in
behind the speaker grill.
Note：
a. Not all Bluetooth devices are guaranteed to pair successfully due to different brand and design.
b. The best working distance for Bluetooth operation is within 10 meters without any obstacle.
c. Please do not put your cell phone next to the unit too close in phone call hands free mode; otherwise,
there will have interference and impact the sound quality reception.
AUX IN/MP3 Link operation
Using the supplied 3.5mm stereo to 3.5mm audio cable and connect the AUX IN jack on the rear panel of unit
to other player( like MP3 player etc..). Then the unit will enter to the AUX IN playback mode directly. Select
and play the music from your player, then the sound will output from radio.
Please kindly note the main control is on your player side. The radio only can adjust the volume, play/pause
function in AUX IN mode.
Specification:
Power source: DC 5V/2A
Output power: 5 W RMS.
FM frequency: 87.5~108.0MHz.
USB rating output: 100 mA.
Bluetooth version: V4.0
Power consumption: <8 W
Standby power consumption: <0.7W
Factory default:
System time: 00：00, 2015-01-01.
Time format: 24hours.
Sleep: OFF.
Alarm duration: 2 minutes
Volume: 15
(The specification may revise without prior notice)
ENGLISH
11
HR10BT
To Next Page
Loading...
