EasyManua.ls Logo

Blaupunkt IR10BT - Troubleshooting and Specifications

Blaupunkt IR10BT
167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. When the setup alarm time is being, the radio will wake up accordingly. Short press the standby button to cancel the alarm
voice. In addition, the alarm will wake up at same time next day.
2. Dual alarm is available for setting.
3. When the alarm is activated, short press other button (except standby) to active snooze function. In addition, the alarm will
wake up again when the snooze time is being.
4. The alarm function is only workable when the main power is connected and available.
5. While the snooze function is working, the remaining snooze time will show on display at same time. Short press standby
function to cancel the snooze.
Sleep
In playing mode(like internet radio, Bluetooth, USB playback mode etc), short press the sleep button repeatedly on remote
controller can switch and select the sleep time between 15/30/60/90/120/150/180/off mode. And the radio will off and switch
to standby mode automatically when the sleep time is being.
Others
For further operation like dimmer, software version, factory default etc., pleaser reference below tree diagram in configuration
setting.
Trouble shooting
1. The speaker cannot turn on.
a. Please check if the power connection is correct.
2. No sound output.
a. Please try to adjust the volume knob, and check the play source.
b. please contact service center for support if the issue remained.
3. Intermittent sound output in Bluetooth mode
a. Please try to move your Bluetooth device more close to the radio.
b. Please reference the manual for re-pairing.
5. The sound output is too small in Bluetooth mode.
a. Please check the volume level your Bluetooth device and radio both.
Specification
Power source: DC IN 9V/2A
TFT 2.4 inch colorful display
Bluetooth version: V5.0
USB 2.0, support music file: MP3/WMA/ WAV/FLAC/AAC(Not guaranteed)
RMS output: 2 x 5W
Power consumption: 16W
Standby power consumption: <1W
(The above spec may update without priority notice.)
Others
For further operation like dimmer, software version, factory default etc., pleaser reference below tree diagram in configuration
setting. Please enjoy it.
9

Related product manuals