Blaupunkt John Deere MP36 - Volume Distribution and Preamplifier Output; Balance and Fader Adjustment; Preamplifier Output Configuration

0
Setting the left/right volume
distribution (balance)
To adjust the left/right volume distribution
(balance),
press the
AUDIO button 5.
"BASS" appears on the display.
Press the
or button : repeatedly
until "BAL" appears on the display with
the current setting.
Press the
or button : to adjust
the balance (right/left).
Press the
AUDIO button 5 to exit the
menu.
Adjusting the front/rear volume
distribution (fader)
To adjust the front/rear volume distribution
(fader),
press the
AUDIO button 5.
"BASS" appears on the display.
Press the
or button : repeatedly
until "Fader" appears on the display
with the current setting.
Press the
or button : to adjust
the volume distribution front/rear.
Press the
AUDIO button 5 to exit the
menu.








Preamplifier output
(Preamp-Out/Sub-Out)
You can use the preamplifier outputs
(Preamp-Out) of the car sound system to
connect external amplifiers. In addition,
you can connect an amplifier for operating
a subwoofer to the integrated dynamic low-
pass filter of the device (level and cutoff fre
-
quency can be adjusted).
For this purpose, the amplifiers must be
connected as described in the installation
instructions.
Adjusting the sub-out level
The sub-out level can be adjusted in 8 incre-
ments (0 to +7).
Press the
AUDIO button 5.
"BASS" appears on the display.
Press the
or button : repeat-
edly until "SUBOUT" appears on the
display.
Press the
or button : to adjust a
value between 0 and +7.
When you have finished making your chang
-
es,
press the
AUDIO button 5 twice.
Adjusting the sub-out cutoff
frequency
You can select 1 of 4 settings: 0 Hz, 80 Hz,
120 Hz and 160 Hz.
Press the
AUDIO button 5.
"BASS" appears on the display.
Press the
or button : repeat-
edly until "SUBOUT" appears on the
display.






Sound Preamplifier output
Alicante_SevMP36_Buch.indb 60 13.02.2006 16:09:18 Uhr