30
Programming with DSC
The car radio offers the facility to adjust cer-
tain settings and functions to your require-
ments and to store these changes with the
aid of DSC (Direct Software Control).
The default settings are selected at the fac-
tory.
An overview of the factory default settings
is provided below for future reference.
To alter a programming setting:
• Press DSC.
Select and adjust the functions described
below by means of the rocker and the ENT
key. The status of adjustment is shown on
the display.
/ Select function
<< >> Adjust/call up value
ANGLE Adjust the display to your
own viewing angle.
DIM DAY Select the display bright-
ness for daylight (Stages 1-
9).
DIM NIGHT Select the display bright-
ness for darkness (Stages
1-9).
The brightness is switched
over automatically by the
headlights.
ON VOL Select the initial volume.
Use << >> to select the de-
sired initial volume.
If “LAST VOL” is selected,
the initial volume is the
same as that last selected.
PEAK ON/OFF
Activate/deactivate the dy-
namic volume level display.
SHARX Automatic bandwidth switch-
ing on the FM band.
Where the station density is
high, switch to SHARX ON
with << >>: this largely elimi-
nates interference from ad-
jacent stations.
“SHARX ON” is the factory
default setting.
HICUT Interference-driven treble
reduction.
Treble frequencies are re-
duced only when interfer-
ence is present. Can be se-
lected from NO HICUT
(OFF) to HICUT 3 (strongest
treble reduction). Decide for
yourself which setting is the
most pleasant.
FM/AM SENS
Change the sensitivity of the
seek run.
“SENS 1” indicates close re-
ception, “SENS 6” distant
reception.
Select “SENS 1” if you wish
to receive strong stations in
the near range; select
“SENS 6” if you also wish to
receive weaker, distant sta-
tions.
To Next Page
Loading...
