This device complies with part 15 of the FCC Rules. Operaon is subject to the
following two condions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operaon.
Changes or modificaons not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protecon against harmful
interference in a residenal installaon. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instrucons, may cause harmful interference
to radio communicaons. However, there is no guarantee that interference
will not occur in a parcular installaon. If this equipment does cause
harmful interference to radio or television recepon, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
To sasfy FCC RF exposure requirements, a separaon distance of 20 cm or more should
be maintained between the antenna of this device and persons during device operaon.
To ensure compliance, operaons at closer than this distance is not recommended.
To Previous Page
Loading...
Need help?
General
