5
RVC701
corresponding plates on the charging station.
4. The display will show “1111” indicating that charging is in process.
5. When charging is complete, the display will show “FULL”.
Tips:
The first charging should take 12 hours.
Charge the robot as soon as possible after the battery has been discharged.
If the robot is not to be used for a long time, make sure the battery is not discharged.
ROBOT ACTIVITY MODES (STATES)
- off: the robot is switched off with the main switch and does not consume power. It will not charge in
the charging station.
- standby state: this state will be reached after the robot is stopped by using the on/off button or the
robot is woken up from sleep with the on/off button
- sleep state: the robot will automatically go to sleep after two minutes of inactivity or 10 minutes if it is
connected to WiFi and the application is being used.
Battery power consumption in sleep mode is reduced. Press and hold the on/off button for 6 seconds
to enter sleep mode.
DEVICE START-UP
Prepare the surface of the room to be cleaned. Remove sensitive objects, cables, sheets of paper. Raise
backdrops, curtains, and drapes hanging to the floor. Cover delicate furniture.
Press the power button to start the robot vacuum cleaner. The robot will start to move and vacuum in
automatic mode.
You can change the vacuum modes with the remote control when the vacuum cleaner is in standby
mode or vacuuming. Press the Mode button to change the vacuum mode.
1111 – Spot cleaning
2222 – Automatic cleaning
3333 – Cleaning along the edges
4444 – Zigzag mode
The vacuum power can be changed by pressing the MAX button on the remote control.
CONTROLLING THE ROBOT
1. Remote robot control
When the robot is in standby mode, it can be moved by pressing the arrow buttons on the remote
control, corresponding to the directions of movement.
2. Programming the schedule using the robot's control panel
A. Setting the robot's system clock
A1. Press the “PLAN” button, the robot will display the currently set time.
A2. Two left digits will start flashing (hour). You can increase their value by pressing the “HOME” button.
Press the power button to set the minutes.
A3. Two right digits will start flashing (minutes). You can increase their value by pressing the “HOME”
button.
A4. Press the power button to save the changes. Press the “PLAN” button to exit the time setting
mode.
B. Setting the scheduled cleaning time
B1. Hold the “PLAN” button for 5 seconds. The last two digits will start flashing.
B2. Select the schedule number by pressing the “HOME” button. Each press of the “HOME” button will
increase the value by one. Confirm with the power button .
B3. Then set the desired hour and minutes.
To Next Page
Loading...
Need help?
General
