Blaupunkt SA 2900R - Page 13

12
6.4.6. Time
This is for you to program the current time to be displayed. (Hour & minute
 Use Up and Down keys to select the Hour and Minute, and press OK to confirm.
6.4.7. Date
This is for you to set the current date.
 Use Up and Down keys to select the Month and Day, and press OK to confirm
6.4.8. Panel Siren
This is for you turn on/off the Control Panel’s built-in siren. When turned off, the Control Panel will not sound any warning when an alarm is activated.
 Siren On is set as factory default.
6.4.9. Special Setting
Special setting provides more function for detail system configuration. The items available include the following – see a) to h):
6.4.10. Alarm Length
This is for you to select the time length siren should sound when an alarm is activated.
 Options available are: 1~15 minute in 1-minute increment.
 3 minutes is set as factory default.
6.4.11. Exit Sound
This is for you to decide whether the Control Panel should sound count-down beeps and volume of beep during Entry Time
 Options available are: High, Low, Off
 Exit Sound Lo (Exit sound Low) is set as factory default.
6.4.12. Entry Sound
This is for you to decide whether the Control Panel should sound count-down beeps and volume of beep during the Entry Time.
 Options available are: High, Low, Off
 Entry Sound Lo (Entry sound Low) is set as factory default.
6.4.13. Interference
This is for you to turn on and off the interference detection feature. When interference detection is turned On, if RF signal jamming is detected
continuously for 30 seconds, the fault event will be logged, reported to programmed telephone number and displayed on the LCD to warn the user.
 Detection Off is set as factory default.
6.4.14. Final Door
If set to On, when the system is being Away Armed and a Door Contact set to Entry attribute is closed before the Exit Delay timer expires, the system will
enter Away Arm mode immediately even if the Exit Delay timer has not expired yet. If set to Off, the system will only enter Away Arm mode after the Exit
Delay Timer has expired.
 Final Door Off is set as factory default.