ENGLISH
E-6
Turn on/off message edit
You can edit the turn on/off message and store it in memory.
Following four messages can be edit with 8 characters each.
Turn-on message
• HELLO (MESG 1) / WELCOME (MESG 2)
Turn-off message
• SEE YOU (MESG 3) / GOOD-BYE (MESG 4)
1. Repeatedly press the
DISP
to display the “MESG ON” on
the display window.
2. Press the
SC/PS
to flash the “HELLO”.
3. Rotate the VOL dial to select the desired message you
want to edit.
HELLO ➜ WELCOME ➜ SEE YOU ➜ GOOD- BYE
4. Press the
SC/PS
, then enter the character.
A. Rotate the VOL dial in a clockwise direction to select
the desired characters.
(A➜ B ➜ C ➜ ...Z➜
< ➜ > ➜ ∗ ➜ + ➜
′
➜ − ➜ ′ ➜ /
➜0➜1➜2➜3...9➜“ ”Space )
B. Rotate the TUN/TRK dial to move the flashing cur-
sor.
C. Repeat steps A. and B. to complete entering the en-
tire message 8 characters max.
Tips
• To erase /correct a message, press the
DISP
for more than
2 seconds to clear the character and re-enter.
• If you make no button input or dial operation in 20 sec-
onds, the message edit mode will turn off automatically.
• Make sure the “MESG” will be “ON” .
• When entering a name, pressing the following buttons af-
fects the display of characters as follows.
1
: Changes to inputting letters. (Starts with “A”.)
2
: Changes to inputting numbers. (Starts with “0”.)
3
: Changes to inputting characters. (Starts with “<”.)
6
: Enters a space (blank).
5. Press the
SC/PS
to store the message.
The new message flashes.
6. To return to the normal radio reception, Press
DISP
.
Erasing the turn on/off message
You can erase the turn on/off message if so desired.
1. Repeatedly press the
DISP
to display the “MESG ON”
on the display window.
2. Press the
SC/PS
, then rotate the VOL dial to select the
desired message you want to erase.
3. Press the
SC/PS
, then press the
DISP
for more than 2
seconds.
4. To return to the normal radio reception, Press
DISP
.
Repeat steps 2. and 3. if you want to erase other mes-
sage.
To Next Page
Loading...
