Blaupunkt SAN REMO CD31 - Page 18

@) EEPROM programmieren
4. Starten Sie die Prozedur mit einem Doppelklick auf das
Kommando z.B.: "Bologna C51".
Im Ausgabefenster des ComServers erscheint 10 x "EEPROM set =
OK".
ASE-ComServer
ae
Programming
Level 0 protected
unline 3
310 Duesseldort C51
1
05
255 tinchen CD51 >>> 86 Commands found <<<
.260 310 Modena CD51
405 319 Kansas DJ51 7 efeht: ‘Startinitialsierung’
1.410319 Maryland DJ51
£420 319 Hawaii DJ51
For ASE-ComServer greater or equal 3.33.
Configurationfile for Funline3 and T-Line2 ASB ECE Radios
‘Hardware-Interface: Maus-Bus inverted
upports TIICA-Diagnosis Box
5/04/01 pg/ASE: Creation.
eigabe wird gestartet.
erat freigeschaltet.
aus-Bus Ok.
‘ommunication-Init = OK
EPROM set = OK
EPROM set = OK
EEPROM set = OK
EEPROM set = OK
EEPROM set = OK
EPROM set = OK
EPROM set = OK
EEPROM set = OK
‘EEPROM set = OK
EEPROM set = OK
2.173 310 Alicante CD31
115 510 Dresden C31
£116 319 Cleveland DJ31
120.510 Dublin C31
.121 319 Madison DJ31
125 510 Boston C31
155 310 Konstanz CD31
.160 310 San Remo CD31
.166 310 Santa Cruz CD31
40 510 Freiburg C31
41 319 Las Vegas DJ31
46 319 San Diego BJ31
74? LEVEL 1 Commands \
Programming the EEPROM
4. Start the Start Up procedure by double-clicking for example
“Bologna C51" command.
The ComServer's output window appears 10 x "EEPROM set =
OK".
- [a \KK7\YKDAVkd_AlK\ Anwender\Bruno\T esthiles\F3_T2_ASB EU_cfg]
Nach dem "Start up" midssen folgende Arbeiten durchgefihrt
werden (die Reihenfolge ist einzuhalten):
* DAA programmieren (Ableich Vor-und Zwischenkreis)
* FM ZF programmieren
¢LSL+ LST FM programmieren (Abgleich FM-Feldstarke)
* LST AM programmieren (Abgleich AM-Feldstarke)
¢ Stereo Schaltschwelle programmieren
¢ FM - Suchlauf - Stopschwellen programmieren
¢ AM-MW/LW - Suchlauf - Stopschwellen programmieren
* RDS Schwelle programmieren
* Auslieferungszustand programmieren
-18-
The following Maus bus commands have to be executed after a
"Start up" (proceed according to the sequence as stated below):
¢ DAA programming (alignment of front- and intermediate r-f circuit)
° FM IF offset programming
«FMLSL + LST programming (alignment of FM field strength)
¢ AM LST programming (alignment of AM field strength)
¢ Stereo threshold programming
¢ FM search stop programming
¢ AM-MW/LW search stop programming
¢FM-RDS sensitivity programming.
¢ Deafult settings