DURBAN224 DAB BT 22.05.19 17:00
9 9
CD / USB / iPod mode
Note:
• If the connected USB data carrier cannot be
seen, “USB ERROR” is briey displayed.
• The time required for reading in the data
depends on the design and size of the USB
data carrier.
Connect the USB data carrier.
Turn on the car sound system. If the USB data
carrier is initially selected as audio source ,the
data are read rst.
Removing a USB data carrier
Switched o the car sound system so that
the data carrier will be correctly unregistered.
Disconnect the USB data carrier.
After you pulled o the data carrier from
the USB port at the front of the device, close
the protective cap of the USB port : .
Selecting tracks/Folder
Turn the tuning button to change to the previous
/next track.
Press the tuning button untill displaythe CUE/REV,
then turn the tuning button to choose the time
point.
Press the tuning button untill display Track
then turn the tuning button to choose folder.
Press the tuning button untill display Folder,
then turn the tuning button to choose track.
Notes:
• Press the button 1 and the display will
show track name.
• Turn the tuning button to select your
desired track.
Interrupting playback
Press the button to interrupt the
playback ("PAUSE") or to continue it.
Scanning all tracks (not in iPod mode)
The scan function scans all available tracks.
Press the tuning button for approx. 2 seconds
to start the scan,or brieftly to continueplaying
the currently scanned track. During the
scanning ,“SCAN” and the le name are
intermittently shown on the display.
To Next Page
Loading...
