DURBAN224 DAB BT 22.05.19 17:00
13 13
Bluetooth
Telephone functions
Answering/rejecting an incoming phone call
With an incoming call, the display alternately
shows "INCOMING CALL" and the number of the
caller. The current audio source is muted and a
ring tone is played via the loudspeakers of the car
sound system.
Note:
If the number of the caller is not being trans-
mitted, the display shows "PRIVATE NUM-
BER" instead of the number. If the number
of the caller is stored together with a name,
the name of the entry and the number are
displayed (see the section "Storing a phone
number in the car sound system" in this chap-
ter).
Press the button to answer the call.
"CALL" and the duration of the ongoing call
are displayed.
Press the button to reject the call or
to end the current call.
The display shows "CALL END".
Notes:
• During the call, you can adjust the volume
with the volume control or mute the
microphone and the loudspeakers with a
short press to the On/O button.
• You can preset the minimum volume for
the call playback in the user menu (see the
chapter"Usersettings", section "Making set-
tings in the "VOLUME" menu", menu item
"HANDSFREE VOL").
• You can switch the call playback back and
forth between the loudspeakers of the car
sound system and the cell phone with the
button.
• If another call is received during an ongo-
ing phone call, the second call cannot be
answered via the car sound system.
• If the car sound system is switched o with
active ignition, it automatically switches
on with anincoming call.This allowsyou to
make the call over the hands-free system.
After the call has ended, the car sound sys-
tem automatically switches o again.
Making a call
In the Bluetooth® menu, select the "DIAL NEW
NUMBER" menu item.
Press the rotary control to open the entry
menu.
You can now enter a phone number with up
to 20 digits.
Turn the rotary control to selectadigit for
the respective position.
Press the rotary control to go to the next
position.
Note:
To return to the previous position in the entry
menu, turn the rotary control until the "<<<"
option is selected, and press the rotary con-
trol.
Press the button to call the number
entered.
"CALLING" and the dialed number are alter-
nately shown on the display.
Twin connect
If you want to connect two Bluetooth® devices
with the car sound system at the same time, Twin
Connect needs to be activated in the Bluetooth®
menu (see the chapter "Additional functions in the
Bluetooth® menu", section
"Activating/deactivating Twin Connect"). If two
cell phones are connected with the car sound
system, one of the connected phones must be
selected as master telephone (see the chapter
"Additional functions in the Bluetooth® menu",
section "Managing paired devices"). Upon activating
Twin Connect, the currently connected telephone is
automatically specied as master telephone. If no
telephone is connected with the car sound system,
the previously connected telephone is specied as
master telephone. In the lift of telephones, an asterisk
symbol ( ) is shown next to the Bluetooth® name
of the master telephone.
Notes:
• Only the master telephone is used for
outgoing calls.
• Y
ou can access only the phone book of the
master telephone.
• You can select the other connected tele-
phone as master telephone at any time.
*
To Next Page
Loading...
