Blaupunkt VCI201 - Page 7

5
5. Switch
6. Cover with the motor
3. Hose holder
4. Hose
1c) Wet and dry floor suction brush
1a) All-purpose floor suction brush
1b) 2-in-1 slotted nozzle
2. Metal tube
1. Suction nozzles:
10. Handle
11. EPA filter
8. Hose connector (inlet hole)
7. Air outlet
9. Cover latches
13. Paper bag
14. Waste container
12. Filter attachment
It is recommended to change the bag, if it appears to be full or when the suction power has decreased.
If using a disposable bag, remove and discard it.
CLEANING AND MAINTENANCE
Clean the EPA filter regularly. It should be pre-cleaned by shaking it. It can be washed under running
water. Install the filter in the vacuum cleaner when it is completely dry.
Wipe the body with the motor using a slightly damp cloth, then wipe it dry.
The waste container can be cleaned under running water.
Regularly clean the suction cups, tube, and hose from hair and other impurities stuck inside.
Replaceable Blaupunkt ACC054 paper bags and EPA Blaupunkt ACC055 filters are available.
BEFORE STARTING THE VACCUUM CLEANER
4. Connect the vacuum cleaner to the power source.
BEFORE FIRST USE
Remove all paper, cardboard, and films protecting the appliance and its parts.
Remove the wheels and accessories from the container.
Fix the wheels into the holes in the base of the vacuum cleaner (push them in).
1. Make sure the EPA filter or bag is properly seated.
3. Install the tubes or the selected accessory on the hose.
2. Connect the hose to the inlet or blow opening.
5. Activate the vacuum cleaner with the main switch.
TIP: The vacuum cleaner can be used to collect water with a suction brush for both wet and dry
vacuuming (1c). Do not do it if a paper bag is installed. If there is too much water collected in the
container, it may escape between the container and the cover with the motor.
VCI201