Blaupunkt Verona CR 43 - Station Tuning Methods; Seek Sensitivity and Audio Modes

Verona CR 43
20
Tuning of Previous Station
• Press rocker switch
/ 2 down. The
radio will automatically seek the previ-
ous station.
If the rocker switch
/ 2 is held
down/up, the seek operation continues
to be carried out quickly in the corre-
sponding direction.
Manual Tuning
It is also possible to tune in stations “by hand”
with this radio:
• Press rocker switch <</>> 3 to the left
or to the right. The frequency band is
scanned in small steps.
Adjusting the Station Seek
Sensitivity
You may also modify the sensitivity of the
automatic station seek operation.
For this:
• press lo rocker switch =.
If “lo” is indicated, only stations with
good reception conditions are captured
(lower sensitivity).
If “lo” is not indicated, stations with a
weaker reception are also captured
(higher sensitivity).
Adjusting the local mode sensiti-
vity
In regions with extremely high station densi-
ty, e.g. in Italy, the set allows you to switch
over the station seek sensitivity for the ocal
mode from “High” (adjusted ex works) to
“Low”. “Low” means that station seek tuning
only captures the most powerful stations.
For modifying the local mode:
• press lo rocker switch = longer than
8 secs.
The display : shows “L” for “Low”.
By pressing lo rocker switch = again longer
than 8 secs., the set switches back to “High”
(display : “H”).
When switching off the unit or when removing
the set with the QuickOut handle the set
remains in the last activated mode.
Switching between Stereo and
Mono
If you wish to switch between stereo and
mono:
• keep the lo rocker switch = pressed
for longer than 2 seconds. The stereo
symbol will appear in the display :
if the stereo mode is activated.
The stereo function is activated automatical-
ly when you turn your set on.
The set will automatically switch to mono if
reception is poor.
Storing a Station
You can store one MW and LW station and 4
FM stations on each of the preset buttons <.
The display will show you the selected wa-
veband (FM, MW or LW) and preset button.
On FM, the display will also give you the
chosen storage level (I, II, III or T).
If you wish to change from one storage level
to another:
• press the FM•T button ?.
If you wish to store a station:
• (for FM only) select the storage level.
To achieve this, press the FM•T button
? until I, II, III or T appears in the dis-
play :.
• tune in the station (see chapter Station
Tuning).
• press the desired preset button < until
the radio resumes play (approx. 2 se-
conds).
The display : indicates which preset
button has been pressed.
The station has now been stored.