10
English
5. Installation
• Check your WiFi signal strength and make sure that the WiFi signal is strong at the
location of your camera. The suggested Internet bandwidth is 1Mbps (upload/
download speed) per camera.
• For best performance, the smartphone needs to be connected to a Wi-Fi network to
receive maximum video stream speed.
• Avoid aiming the lens at a strong light sources directly (such as sun, laser etc)
• If you desire to install a MicroSD card we recommend doing it before the installation
process. Please refer to chapter 5.3 MicroSD installation for more information.
• Place the camera on the desired installation point and check the live video stream on
the app to ensure that everything to monitor is well in view.
• Check if there is a power socket is in sucient proximity, the VIO-HS20 has a USB
cable of 2m
5.1. IMPORTANT – Read before installing
5.2. Wall or ceiling installation
Take out the mounting map
sticker from the accessories bag and stick
it on the wall or ceiling.
Use the mounting map
sticker as a template to mark the two
drilling points.
Drill through the marked
points and install the plastic anchors on
the two holes.
Place the mounting bracket
on the wall and drive the screws into the
plastic anchors until they are ush with
the mounting bracket and the bracket is
at against the wall.
Install the camera on the
mounting bracket and turn it clockwise
to lock it.
Adjust the camera and check
the live video stream on the app to
ensure that everything to monitor is well
in view.
Step 1:
Step 2:
Step 3:
Step 5:
Step 6:
NOTE:
The Micro SD-Card is mandatory for local recording. Please make sure the Micro SD-
Card is CLASS10 rated. Supported are Micro SD-Cards from 8GB to 64GB.
5.3. Micro SD Card installation
Locate the Micro SD-Card compartment at the bottom of the HS20. (refer to
chapter 2 point )
Install the Micro SD-Card into the indicated MicroSD-card slot.
8
Step 1:
Step 2:
1. Screws
2. Mounting bracket
3. Plastic anchors
4. Wall / Ceiling
1
Step 4:
2 3 4
1
2
3
4
To Next Page
Loading...
