11
English
• Please turn o the power and unplug the power cable, if there is any smoke,
upleasant smell, or noise. Please contact your local retailer or customer service
center for help.
• Avoid oil stain and or chemicals tarnishing and damaging the lens surface.
• All the examination and repair work should be done by qualied service engineers.
We are not liable for any problems caused by unauthorized modications or
attempted repair.
6. Maintenance and troubleshooting
6.1. Firmware Upgrade
If you want to have the latest features or
the app request to update the camera
rmware go to the camera dashboard -->
settings icon --> Device Firmware Version.
If there is a new rmware available the
camera will let you update to the latest
rmware version. Tap “Update” to start the
rmware upgrade.
This process will take a couple of minutes,
after the rmware upgrade is nished the
camera will reboot.
6.2. Factory Reset
Press the reset button (refer to chapter 2 point ) for 15 seconds until the
red Indicator light turns on and starts ashing.
Wait until the green indicator light ashes slowly.
Now the camera is reverted to default settings
5
- If the registration failed check the Wi-Fi password and try again.
- If the camera registration is still not working, perform a factory reset. For more
information refer to chapter 6.2. Factory Reset
- In very rare cases while you’re scanning the QR code, the app may show you a
message that the MAC of the camera is already registered on the database. In this case,
contact our Support Team, refer to chapter 8. Technical Support for more information.
- For more information about manuals, rmware versions, etc., visit our website or
contact your local service support. http://security.blaupunkt-service.com
Step 2:
Step 3:
Step 4:
6.3. Troubleshooting
Plug in the camera and wait until the red Indicator light turns o and the
green indicator light starts ashing.
Step 1:
To Next Page
Loading...
