6
English
Download and install the “Cam4Home Plus” APP to
your Smartphone from the App Stores.
3. Learn in a Camera
For iOS
and Android
Connect your smartphone to your Wi-Fi network.
Open the “Cam4Home Plus” APP. Press the “sign up” button and create an
user account.
To add a new camera tap the “+” button
at the top right of the screen.
Focus with the camera of your smartphone
over the “QR Code” sticker located at the back of the
camera. After the “QR Code” was scanned successfully
tap “next”. If it’s not possible to scan the “QR Code” press
“Serial numer adding” and type in the (S/N) Number
located at the buttom of the camera.
Type the password of your Wi-Fi
network and tap “Next”.
Conrm that the green LED is ashing slowly and
tap “Next”.
Step 1:
Connect the power supply cable to
the camera and to the power line socket to power
ON the camera. The red Indicator LED will turn on
and the device will start booting. Press “Next” on
the app.
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
For security reasons type in a individual camera password. (Password
must contain at least 8 characters, including at least 2 of the following: Capital letters,
small letters, number and special characters. Please do not use any of the following
characters: & ‘ , “ . Now the camera will connect to the cloud this could take up to 60sec.
Step 8:
NOTE: If you are using a dual-band router, make sure that your smartphone is con-
nected to a 2.4 GHz WiFi Network and not to a 5GHz Wi Network. To learn more
about this please check your router manual.
QR-Code
To Next Page
Loading...
