Blaupunkt XLb 250 A - FUNCTION CONTROL

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Remote (REM) : Connect Remote to the electrical aerial output / remote output of your radio with
remote cable
+12V : Connect +12V power supply to the car battery with power cable (power connection)
Power (GND) : Ensure the chassis of the vehicle is connected to the Ground correctly (remove paint
to reveal bare metal if needed) with ground cable
FUSE : Protects device from voltage supply damage.
Power Indicator Light
LEVEL : Adjust the input gain of the unit to accept deaerent level of input signal
CROSSOVER : Full / L.P.F (low pass lter)
FILTER : Adjust L.P.F. frequency (40Hz – 250Hz)
INPUT (R) : Connect it to the RCA output of the car radio with RCA cable
INPUT (L) : Connect it to the RCA output of the car radio with RCA cable
1
4 5 6 7 8
9
10
2
3
FUNCTION CONTROL
3