Blaze BLZ-ICEMKR-50GR

Questions and Answers

J
Joseph WatsonAug 16, 2025
What to do if my Blaze BLZ-ICEMKR-50GR doesn’t operate?
- J
  Janet ReyesAug 16, 2025
  If your Blaze Ice Maker isn’t operating, there are several potential causes: * The ice maker might be unplugged. Ensure it is properly plugged in. * A fuse may be blown, or a breaker flipped. Replace the fuse. If this recurs, call for service to check for a short circuit. * The power button could be off. Switch the ice maker power button to the ON position. * The ice storage bin might be full. Remove some ice cubes and ensure the ice-full probe is free of ice.
M
Matthew WoodAug 19, 2025
Why does my Blaze BLZ-ICEMKR-50GR Ice Maker stop suddenly while making ice?
- A
  angelajohnsonAug 19, 2025
  Your Blaze Ice Maker might stop suddenly due to a few reasons: * There could be a power outage. Reconnect the power supply line. * The ambient temperature might be outside the specified range. Disconnect the ice maker and wait until the temperature is within range. * The ice storage bin could be full. Remove some ice cubes and ensure the ice-full probe isn't obstructed.
I
ilinAug 22, 2025
What to do if water is leaking out of my Blaze BLZ-ICEMKR-50GR?
- R
  Rebecca FranklinAug 22, 2025
  If you notice water leaking from your Blaze Ice Maker, consider these possibilities: * Some water falling when opening the door is normal condensation. Take care when removing ice. * The water supply connection might be leaking. Tighten the fitting. * The drain pipe might be higher than the drain outlet. Lower the drain pipe.
M
Mary JohnsonAug 25, 2025
What to do if my Blaze Ice Maker makes ice, but the bin does not fill up with ice?
- W
  websterkristieAug 25, 2025
  If your Blaze Ice Maker is making ice, but the bin isn't filling, check the following: * The condenser might be dirty. Clean the condenser. * The airflow to the ice maker may be obstructed. Check the installation. * The ambient and water temperatures could be too high, or the unit is near a heat source. Check the installation.
T
Troy BarryAug 28, 2025
Why is my Blaze BLZ-ICEMKR-50GR Ice Maker so noisy during operation?
- C
  Christopher MyersAug 28, 2025
  If your Blaze Ice Maker is making excessive noise, consider these factors: * The feet might not be leveled and locked. Level and lock the feet. * Certain sounds are normal during operation.
A
Amy Williams DDSAug 30, 2025
Why is water leaking from the ice storage bin of my Blaze BLZ-ICEMKR-50GR?
- C
  Cheryl JonesAug 30, 2025
  If water is leaking from the ice storage bin of your Blaze Ice Maker: * The drainhole below the ice storage bin might be blocked. Remove the ice storage bin and clean the drainhole. * The drain hose could be kinked or improperly placed. Check the drain hose to ensure water can drain freely.
L
Lisa WheelerSep 3, 2025
What to do if scaling occurs frequently inside my Blaze Ice Maker?
- D
  Douglas DavisSep 3, 2025
  If scaling occurs frequently inside your Blaze Ice Maker, it's likely that the water hardness level is too high. Install a water-softening device in front of the water inlet.
P
patricksmithSep 6, 2025
Why won't water feed into my Blaze BLZ-ICEMKR-50GR after it starts?
- S
  smithnicholasSep 6, 2025
  If water isn't feeding into your Blaze Ice Maker after it starts: * The water supply tap may be turned off. Turn on the water supply tap. * The water supply pipe might not be properly connected. Reconnect the water supply pipe.
W
Wendy BellSep 8, 2025
What causes the body of my Blaze Ice Maker to be electrified?
- S
  Shawn LopezSep 8, 2025
  If the body of your Blaze Ice Maker is electrified, the ground line might be missing from the socket. Use a socket meeting the grounding requirements.
T
Tyler RubioSep 12, 2025
What causes partially formed or white cubes in my Blaze Ice Maker?
- M
  Mary Weaver DVMSep 12, 2025
  If the ice cubes from your Blaze Ice Maker are partially formed or white on the bottom: * There might not be enough water in the water trough. Check if the water supply pressure is below 15 psig. * The water supply or filter may be restricted. * Check for a water leak at the water trough.

Summary

ICE MAKER SAFETY

IMPORTANT SAFETY INSTRUCTIONS

Essential safety precautions to reduce risks like fire, electric shock, or injury.

IMPORTANT SAFEGUARDS

Crucial precautions for safe usage and installation, covering electrical, environmental, and operational aspects.

Electrical Connection

Details on proper grounding, outlets, and avoiding extension cords for electrical safety.

ICE MAKER INSTALLATION

Unpacking

Steps for removing packaging materials and initial cleaning before use.

Location requirements

Guidelines for selecting a suitable installation site, including clearances and environmental conditions.

Electrical requirements

Specifies the need for a grounded 3-prong outlet and dedicated circuit for safe operation.

Leveling the ice maker

Instructions on how to ensure the unit is level for proper water flow and ice production.

Reversing the door swing

Step-by-step guide for changing the direction of the ice maker's door swing.

Water Supply

Details on connecting the water line, required pressure, and temperature.

Drain

Instructions for connecting the drain line for proper water removal and preventing leaks.

Installation Types

Explains mobile, enclosed, and built-in installation options and their specific requirements.

OPERATION

Final Check List before Operation

A comprehensive checklist to ensure all conditions are met before starting the ice maker.

Operating method

Step-by-step guide on how to start and operate the ice maker and understand its cycles.

How the machine makes ice

Explains the freeze and harvest cycles involved in the ice production process.

How the machine uses the water

Describes the process of water circulation and freezing for ice cube formation.

Normal sounds

Identifies common sounds the ice maker might produce and their potential causes.

Preparing the ice maker for long storage

Instructions for safely draining and preparing the unit for extended periods of non-use.

CLEANING AND MAINTENANCE

What parts should be kept clean

Lists the key components of the ice maker that require regular cleaning for optimal performance.

Exterior cleaning

Guidance on cleaning the outer surfaces of the ice maker using mild detergents.

Interior cleaning

Steps for sanitizing the interior, water trough, and ice storage bin.

Condenser cleaning

Procedures for cleaning the condenser to ensure proper airflow and prevent overheating.

Water distribution tube cleaning

Instructions on how to clear blockages in the water distribution tube for consistent ice production.

Ice-making system cleaning

Methods for cleaning mineral scale buildup from the ice making system.

Control Panel and Ice Size

Control Panel Overview

Explains the control panel layout, buttons, and LED indicators for operating the ice maker.

Ice Size Adjustment Guide

Instructions on how to adjust the size of the ice cubes produced by the machine.

TROUBLESHOOTING

Before Calling for Service

Advice on initial troubleshooting steps to resolve problems before contacting support.

Troubleshooting Guide

A detailed table listing problems, their possible causes, and probable corrections.

LIMITED WARRANTY

1 Year Warranty

Outlines the terms and duration of the manufacturer's warranty for the ice maker.

Warranty claim procedure

Steps to follow when requesting warranty service or parts for the product.