To Next PageTo Next Page
Need help?Do you have a question about the blazer C6304 and is the answer not in the manual?
General| Brand | blazer |
|---|---|
| Model | C6304 |
| Category | Automobile Accessories |
| Language | English |
Recommends AA lithium batteries and explains the amber indicator's meaning.
Install fresh AA batteries into each light base per indicated polarity.
Connect the transmitter to your "four-flat" trailer plug on the vehicle.
Attach the transmitter to a steel surface in the rear of the towing vehicle.
Turn the switch located on the bottom of the "LH" base to "On".
Attach lights on a flat surface, as far apart as practical and at equal distance.
Detach lights by tipping to disengage the magnetic base before repositioning.
Use a tie wrap to collect any loose cable between the lights.
Verify operation of tail, stop, and turn signals. Do not drive if lights don't function.
Check battery LED indicator and light functions every two hours.
Switch off lights after use, store components separately to keep magnets clear.
Kit is designed for standard 12-volt vehicle systems.
Confirm brake, turn signal, and running lights operate correctly every 2 hours.
Battery performance may decrease below 20°F; check indicator and replace as needed.
Do not submerge lights or transmitter in water to prevent damage.
Always have a spare set of eight AA batteries on hand for extended trips.
Details the transmitter's wire colors for tail, brake, and turn signals.
If lights don't function, check or replace all batteries first.
If signals are reversed, swap the yellow and green wires on the transmitter.
If only some functions work, check the four-flat trailer connector wiring.
Check for corrosion on four-flat plugs and clean with baking soda.
Do not operate towing lights farther than 65 feet (19.8 meters) from the transmitter.
States compliance with FCC rules and potential interference issues.
Complies with FCC and Industry Canada radiation exposure limits for uncontrolled environments.
