23
SECTION 8 - OPERATING BLEC CULTI-PACK SEEDER
MODELS - CP36/CP42
STARTING WORK CONTINUED....
8. Position the seeder at required area, switch the seed lever ON and engage the clutch.
9. IMPORTANT
When starting to move off, it will be beneficial to stand off the footplate
to allow initial traction to take place.
10. The seed can be switched ‘ON’ and ‘OFF’ on the move by the lever.
11. The operator can easily observe the seeded area by the rolled lines produced by the
notched rolls.
12. If possible we recommend you make 2 passes in different directions, this will
incorporate the seed more effectively. The 2nd pass can be just a rolling pass with
the seed being spread only on the first pass.
13. Large areas can easily be seeded quickly with the CULTI-PACK SEEDER.
14. After seeding, no other operations are necessary. The ribbed surface will be firmed
up by rainfall, leaving an ideal seedbed.
To Next Page
Loading...