BLK BOX WALL MOUNTED PULL UP BAR - Bolt Assembly to Wall

#MADEINBELFAST
2
BOLT ASSEMBLY TO WALL USING 16 QTY SLEEVE ANHOR BOLTS (10.0031) AND 16QTY M10
WASHERS (10-0024) DRILL HOLES AND MOUNT USEING GUIDE AS SHOWN BELOW,
TIGHTEN ALL BOLTS TO SPESIFIED TORQUE.
30
Nm
DRILL HOLE
VACUUM HAMMER IN
BOLT
TIGHTEN
90MM
SLEEVE ANCHOR BOLT FITTING
-DRILL 10MM HOLE IN WALL, 90MM DEEP USING
PLATE AS A GUIDE.
-VACUUM OUT THE DUST.
-HAMMER SLEEVE ANCHOR INTO THE HOLE.
-TIGHTEN SLEEVE ANCHOR TO SPECIFIED TORQUE
USING 13MM SPANNER.
10.0031
10.0019
30
Nm
x 16